Nine methods for energy saving of agricultural pumps

First, adjust the pump's ramp and reduce the elbow. Rotate the pump ramp or volute so that the outlet faces the pool directly. This helps to minimize flow resistance and improve efficiency. Second, shorten the pipeline. By removing a 1-meter section of pipe, you can save approximately 0.21 kg of diesel over 10 hours of operation. Third, increase the water pipe diameter. Replacing a 10-cm hose with a 15-cm tube for a 4-meter length can save about 0.5 kg of diesel in 10 hours. A larger diameter reduces friction loss and improves flow. Fourth, keep the water clean by removing the filter if it's not necessary. This can help maintain smooth water flow and reduce maintenance time. Fifth, replace the ring and adjust the axial gap. Make sure the impeller and axial clearance are properly set according to the manufacturer's instructions. Incorrect clearance can lead to inefficiency and wear. Sixth, clear any blockages in the pipeline. Foreign objects in the inlet pipe, impeller, or diversion channel can significantly reduce water flow and increase energy consumption. Seventh, prevent air from entering the pump. Air in the system can drastically reduce water intake and cause cavitation. Check and maintain the sealing parts regularly. Eighth, use direct coupling instead of a belt drive. Direct coupling improves transmission efficiency and reduces energy loss during operation. Ninth, eliminate "anti-aircraft" type outlets. These types of outlets create unnecessary turbulence and increase energy consumption. Using a more streamlined design can improve performance. By implementing these simple adjustments, you can significantly improve the efficiency of your pump system, reduce fuel consumption, and extend the lifespan of the equipment. Regular maintenance and proper setup are key to achieving optimal performance.

Structural Steel Pipe

The structure Steel Pipe has hot - rolled seamless steel tube and welded steel tube.The seamless steel tube for structure is divided into two types according to the provisions of "seamless steel tube for structure" (GB/ t8162-2008) : hot rolling (extrusion, expansion) and cold drawing (rolling).The outer diameter of hot-rolled steel pipe is 32-630mm and the wall thickness is 2.5-75mm. The outer diameter of cold-drawn steel pipe is 5-200mm and the wall thickness is 2.5-12mm. Welded steel pipe is made of Steel Plate or steel strip after crimping and forming, which can be divided into straight welded steel pipe and spiral welded steel pipe.The outer diameter and wall thickness of the direct-welded steel pipe are 5-508mm and 0.5-12.7mm respectively, which shall comply with the provisions of GB/ t3793-2008.The welded steel pipe for low-pressure fluid transportation is also called common welded pipe, commonly known as clark pipe. The specification is expressed in mm of nominal diameter, which should comply with the provisions of GB/ t3091-2008 for low-pressure fluid transportation.

Structural Steel Tube,Carbon Structural Tube,Api 5L Steel Pipe

Shandong Guanzhou Iron and Steel Group Co., Ltd. , https://www.guanzhousteel.com